Cross cutting machine operation precautions

Cross Cutting Machine operation precautions

(www.flyingmancuttingmachine.com)

1. Before the cross cutting equipment is put into operation, check whether the various work positions are properly adjusted. Lubricate the parts and grease grease should be added in advance. Check if the tool is sharp.

After everything is normal, you can run the empty car first, check for any abnormalities, and enter the processing order into the computer for inspection.

2. After the cross cutting machine is put into operation, the best working conditions of the equipment should be adjusted in time according to the production conditions to ensure that the slitting machine is moderately indented, cut without burrs, and the sides are properly trimmed. To ensure that the cross-cutting machine smoothly discharges and discharges paper, and the cutting length is accurate. The cross-cutting machine that connects the production management also needs to monitor the operation of the cross-cutting machine from time to time to prevent the paper jamming phenomenon and the production of defective products.

3. After the work is completed, promptly clean up the accumulated dust and paper scraps on the equipment, check the cutters and grinding wheel, and drain the water in the high oil and water accumulator and the gas storage tank, and check whether there is any abnormality in the running parts. Then, cut off the power according to the operating requirements of the manual and maintain the computer operating system.

Fourth, we must do a good job of maintenance and maintenance work. First of all, the daily maintenance should be in place. The principle is that lubrication, cleaning and cleaning (dust free, no debris) are in place to ensure that the sliding parts of the equipment are in good condition. Followed by maintenance work, regular and irregular inspections should be performed on rotating parts (especially real-time monitoring of wearing parts). The implementation of regular adjustments, regular replacement, and make detailed records to achieve the purpose of extending the service life of the equipment. The electrical parts should be regularly cleaned and inspected to eliminate hidden dangers in time.

Fifth, use high-quality slitters and cross cutters.

Sixth, to improve the technical quality and level of operators, for the control part of the operation to be responsible for the person, without permission, no one can operate on their own.

From Suzhou Flying Man Assembly Automation Co., Ltd.

Sales email: jennygu@flyingman.cc